Yuav Ua Li Cas Ua Pwm Rau Lub Tsev Ntxuav Pob Zeb

Cov qauv rau cov pas dej pob zeb yog ib feem tseem ceeb ntawm txheej txheem tsim kho, vim lawv muab kev txhawb nqa qauv thiab siv tau los kho dua cov saum pas dej qub lossis puas lawm. Txawm koj muaj ib lub pas dej pob zeb laus uas xav tau kho lossis ib qho tshiab uas xav tau ib lub qauv tshwj xeeb, tsab ntawv no yuav coj koj mus txog txoj kev ua ib qho siv cov khoom yooj yim uas pom hauv feem ntau khw muag khoom siv.

(Yuav Ua Li Cas Ua Pwm Rau Lub Tsev Ntxuav Pob Zeb)

Cov khoom siv xav tau:

* Dej
* Cov tshuaj ntsuam yas
* Cov raj ntawv cardboard
* Yas npog lossis daim nplaum
* Xim (xaiv tau)

Kauj ruam 1: Npaj koj qhov chaw

Ua ntej pib, nws tseem ceeb kom npaj qhov chaw uas koj npaj yuav tso lub qauv. Qhov no suav nrog tshem tawm txhua yam khib nyiab thiab ua kom thaj chaw sib npaug kom cov qauv haum sib npaug. Koj kuj yuav xav ntxuav saum npoo nrog dej thiab kua vinegar ua ntej muab cov qauv tso rau saum nws.

Kauj ruam 2: Ntxuav thiab ua qauv lub tais da dej

Siv cov tshuaj ntsuam yas, pour water into the center of the plastic tube, creating a depression in the middle. Place the concrete sink on top of the depression and secure it with a wooden stake. Allow the concrete sink to set according to the manufacturer’s instructions.

Once the sink has set, remove it from the trap so that it is ready for the next step.

Kauj ruam 3: Build the mold

To build the mold, start by cutting several cardboard tubes into the desired shape. Cut them to the appropriate length and make sure that they fit snugly around the edge of the concrete sink. Using the plastic syringes, pour water into each cardboard tube until it reaches the bottom of the depression. Tom qab ntawd, use a card to close off each end of the tube, securing it in place with a rubber band or piece of tape.

Kauj ruam 4: Apply paint if desired

If you prefer, you can apply paint to the mold to give it a professional-looking finish. Simply spray the paint onto the cardboard tubes and let it dry completely before filling the depression with concrete.

Kauj ruam 5: Pour the concrete

With the mold in place, pour concrete over the until it covers the entire depression. Let the concrete cure according to the manufacturer’s instructions, typically taking at least a week.

Kauj ruam 6: Remove the mold

When the concrete has hardened, remove the mold from the sink. Be careful not to damage the concrete or the surrounding walls when removing the mold.

(Yuav Ua Li Cas Ua Pwm Rau Lub Tsev Ntxuav Pob Zeb)

Zoo siab txais tos! You have successfully made a mold for a concrete sink using the materials available in most hardware stores. With practice, you can create molds for a wide variety of sink tops, including angles, curves, and even intricate designs. Ua tsev zoo siab!
hot tags: concrete,concrete additives